Routing Map Filters

Below the Map and Satellite bar, is another bar that shows total number of potential deliveries on the map as well as total number of estimated gallons for the day.

Finally the filter bar, probably the more important bar before geting a route ready. The bar itself is divided into 3 sections each used for filtering purposes

The first sections is for filtering routes

• All - Shows all customers on the map for routing
• Routed - Shows only customers that have been added to routes
• Important - Shows the more pressing deliveries that need to be made
• Requested - Shows Deliveries that were requested by the customer
• Load - Shows loads that have been built but need to be added to a route
• Builder
• Sequence - Routes that have been loaded and sequenced showing a route

Next is the customer filter

• Holds - Shows customers on the map that have holds on their accounts
• Auto - Shows customers that have auto deliveries set up on their acount

Finally The Lasso tool, this tool is primarily used when setting up a load for a route. The tool allows for a "Lasso" to be made using points around a selected area. The points then create a zone and everything inside of the zone can then be added onto a load which can then be added to a route. The tool shows the following

• Undo - Clicking on it deletes a previous point added on the lasso
• Check - Clicking on the check will close out the Lasso and create a zone
• X - Clears out the created zone and allows for the creation of a new one